Launch X-431 PRO MINI - 2 PREPARATIONS; 2.1 CHARGING X-431 PRO MINI; 2.3 POWER ON;OFF

LAUNCH X-431 PRO MINI User Manual
6
2 Preparations
2.1 Charging X-431 PRO MINI
1. Plug one end of the included power adaptor into the USB port of the X-431
PRO MINI.
2. Connect the other end to the AC outlet.
If
appears on the screen, it indicates it is being charged. If the logo changes
into
, it indicates that the battery is fully charged. Unplug the power adaptor
from X-431 PRO MINI.
2.2 Using your battery
 If the battery remains unused for a long period of time or the battery is
completely discharged, it is normal that the tool will not power on while being
charged. Please charge it for a period of 5 minutes and then turn it on.
 Please use the included power adaptor to charge your tool. No responsibility
can be assumed for any damage or loss caused as a result of using power
adaptors other than the one supplied.
 While X-431 PRO MINI has low battery, a beep will sound. If it is very low,
X-431 PRO MINI will be switched off automatically.
2.3 Power on/off
2.3.1 Power on
Press [POWER] to turn the tool on.
Note: If it is the first time you have used this tool or the tool remains idle for a long
period of time, the tool could fail to turn on. Please charge the tool for a minimum of 5
minutes and attempt to turn on again.
2.3.2 Power off
Press [POWER] for 3 seconds, an option menu will pop up on the screen. Tap
“Power off” to turn the tool off.
2.4 Tips on finger operations
Single-tap: To select an item or launch a program.