Launch X-431 V - 3 Network Setup; 3.1 Connect to a WLAN Network; 3.2 Disconnect from a WLAN Network

LAUNCH X-431 V V4.0 User Manual
10
3 Network Setup
Note: If you don’t need to use WLAN for a while, you can turn it off to conserve
battery life.
The tablet has built-in WLAN module that can be used to get online. Once you’re
online, you can register your tool, surf the Internet, get apps, send email, launch
the remote diagnosis, and check for software updates etc.
3.1 Connect to a WLAN Network
1. On the home screen, tap Settings -> Network & Internet -> WLAN.
2. Slide the WLAN switch to ON, the tablet starts searching for available
wireless networks.
3. Select a wireless network,
 If the chosen network is open, the tablet will connect automatically.
 If the selected network is encrypted, a network password will need to be
entered.
4. When “Connected” appears, it indicates the WLAN connection is complete.
Once it is connected successfully, tap the desired network from the list to view
its name, link speed, security type, IP address etc.
When this tablet is in range, it will connect to the previously linked network
automatically.
3.2 Disconnect from a WLAN Network
1. On the home screen, tap Settings -> Network & Internet -> WLAN.
2. Tap the network with a Connected status, then tap “Disconnect”.