LAUNCH X-431 V V4.0 User Manual
67
A. If it is the first time you have operated this printer, please proceed the
following:
2. For initial use, you are suggested to reset the printer: Press and hold [MODE]
& [FEED] for 8 seconds, the following resetting command will be printed out:
at + default = 1
ok
at + reboot = 1
rebooting...
1. Tap “Reset” to configure the printer.
Step 1: Connect the printer:
Tap “Scan” to start scanning and select the desired printer hotspot named
with X-431PRINTER-XXXX (XXXX stands for 4 characters), and then tap
“Connect” to enter Step 2.
Step 2: Join the printer into LAN:
Tap “Scan” to select the desired local WLAN network from the list, and type in
the security password (If it is an open network, password is not required), and
then tap “Confirm”.
4. Once the WLAN network of the printer is connected and the printer is found,
tap “Printing test” to test the printing.
Now you can use the printer to print!
If the printer is not found, please reset the printer to default factory settings (refer
to Step 2 for details) and check whether the current device and the printer are on
the same LAN.
B. If you have configured the printer to the LAN:
2. Tap “Connect to Printer”:
To Next Page
Loading...
