Launch X431 Scopebox - Display Settings; Channel and Cursor Measurement

LAUNCH X431 PAD Scopebox User’s Manual
input. Moreover, calibration may take several minutes and please be patient to
wait.
3.3.4 Display settings
Click “View” and then [Display settings] to enter the setting screen. See Fig.
3-9.
Fig. 3-9
Click “Vectors” or “Dots” to define display
mode. Check/uncheck the box
before Grid to open/close grid display.
3.3.5 Channel and cursor measurement
<1> Channel measurement
Click “Measure” and then [Source], a screen similar to Fig. 3-10 will appear.
Fig. 3-10
<2> Cursor measurement
Click “Measure” and then [Cursor Measure], a screen similar to Fig. 3-11 will
appear.
Not
e: if no desired channel is selected, the system will take the current source
as the default channel.
12