Launch X431 Scopebox - 3.3.2 Trigger Setting

LAUNCH X431 PAD Scopebox User’s Manual
Fig.3-1
Button descriptions:
[Autoset]: It indicates a
u
to trigger setting. Based on the characteristics of
measured signal, the oscilloscope will automatically set the horizontal baseline,
vertical sensitivity and trigger condition so that the waveform can be displayed.
[File]: provide
s
waveform record and waveform replay.
[View]:
Calibration and display settings are available.
[Measure]
: includes signa
l source measurement, cursor measurement and
clear measurement.
[Settings]: display
s or hides the parameter settings area including horizontal
settings, vertical settings and trigger settings.
[Start/stop]: start
s/stops collecting oscilloscope waveforms.
3.3 Operations
3.3.1 Channel selection and attributes setting
<1> Channel selection
There are two ways available for channel selection: (See Fig. 3-2)
A. Select from the channel column shown at the bottom of the waveform
7