LAUNDRY SOLUTION SX205100A - Electric Connection

SX205100A Dryer Controller
2.2. Electric connection
220VAC/ 24VDC
L
COM1
220VAC/ 24VDC
COM2
Com1
Fwd
Rev
Heat 1
Heat2
Fan
Cool
Al arm
Com2
Power input
Gnd
I nput
Emergency Stop
Overheat
Motor overload
Door Single
Gnd
Outdrum temperature
Indrum temperature(Optional)
Wiring chart
1
2
3 4
5
6
7 8
9
1
2
1
2
3
1
2
3 4 1
2
3
4
5
N
NOTE：This drawing is only for reference.
Note:
（1） The diagram above is only for reference.
（2） Voltage outputs of the transformer is AC9.8V (loaded voltage), do not directly connect to AC
220V.
（3） The transformer should be configured by users if the input voltage range of the transformer is
out of the of : AC220V(±10%).
（4） Voltage connected with relay ≤ AC220V (DC 24V); Relay current < 5A
（5） Output to carry an electric voltage for connecting, the customer can connect into according to
own effective demand, needing not certainly AC220V.
（6） Do not use the port standby.
（7） Make sure the temperature around the controller and the connecting cable is lower than 60℃.
7/16