LAVAZZA LB GUZZINI - Installation; Mounting-Positioning; Electric Connection

3
M
aintenance manual for technical assistance - LB GUZZINI
Manual code 10083088 / Rel. 0.00 / January 2008
2.1. Stop functions
To stop the machine turn the main switch to “0” (OFF).
2.2. Safety devices / Residual risks
The construction characteristics of the machine,
described in this manual, do not protect the user
against a direct jet of steam or hot water.
Warning
Do not use any containers that are not suitable for
foodstuffs.
3. INSTALLATION
3.1. Mounting-Positioning
Warning
It is prohibited to install the machine outside or in
places where water or steam jets are used.
Warning
The presence of magnetic fields or proximity with
electric machines which generate disturbances,
may cause malfunctions in the electronic control of
the machine.
W
arning
With temperatures approaching 0°C there is the
risk of freezing internal parts of the machine which
contain water. Do not use the machine under these
conditions.
For the correct operation of the machine the following
advice is given:
- environmental temperature: 10°C ÷ 25°C;
- maximum humidity: 65%;
- the area must be ready for the installation of the
machine;
- the place where the machine is installed should be
flat, solid and still; the surface must not have an incli-
nation of more than 2°;
- the area should be sufficiently illuminated, ventilated,
hygienic and equipped with a readily available power
outlet.
Attention
Sufficient space must be allowed to access the
machine and the plug, to allow the user to move
freely and to be able to immediately leave the
area in an emergency.
Note
The machines described in this publication, are
designed in compliance with the specific european
standards in force and therefore have measures of
protection in all the potentially hazardous parts.
Attention
Burn danger – During hot water and steam
dispensing, do not direct the jets toward others
or yourself.
Warning
Check that the surface prepared for the machine
installation, has dimensions and sturdiness suitable
to safely support the machine.
Note
For a correct ergonomic use of the machine, place
it on a working surface not lower than one meter
from the floor.