LAVAZZA LB2317 - Page 44

English
8
44
MENU ITEM Description
AquaClean Filter
This function allows you to manage installation and maintenance of the AquaClean filter.
Available options depend on the presence of an already installed filter.
In case a Brita filter is already active, the screen "Turn off and Remove Brita to Enable
AquaClean" is shown
In case no filter is active - and you have not dispensed more than 5 litres since the last descaling -
the screen "Activate AquaClean Filter?" is shown
The screen "Descale Before Activating Filter" is shown in the following cases:
- No filter is active, but more than 5 litres have been dispensed since the last descaling cycle;
- An AquaClean filter is already active, but has been used up;
- An AquaClean filter is already active, but it is the eighth of eight filters
In case there is an active AquaClean filter - and you have not dispensed 1 litre of water since its
activation - the screen "Filter Already Activated" is shown
Turn off and Remove Brita
to Enable Aquaclean
This screen is shown for 3 seconds and then it automatically goes to the "AquaClean
Filter" page
Descale Before Activating
Filter
This screen allows to activate the descaling cycle. Once this cycle is complete, all filters are restored to the
deactivation initial status
- OK:
the preparatory steps for starting the descaling phase are shown
- EXIT:
goes back to the "Water Filters Management" page
Filter already Activated This screen is displayed until the user selects OK
Activate Aquaclean Filter?
Confirmation to proceed is requested with the activation of the AquaClean filter:
- YES:
the filter activation procedure starts
- None:
goes back to the "Water Filters Management" page
Insert Filter Fill Water
Tank
A preliminary instruction is provided when activating the filter:
- OK:
go to the next step
- EXIT:
goes back to the "Water Filters Management" page
Place Container Under the
Water Spout
A preliminary instruction is provided when activating the filter:
- OK:
filter activation start
- EXIT:
goes back to the "Water Filters Management" page
Exit Through this option the user can go back to the menu top level
Errors management
This function allows you to manage and view the machine errors:
- Errors list
- Reset Errors
Press the OK button on the EXIT option to go back to the top level
Errors list
This function allows you to view the machine errors: - Error code:
displays the number code relating to the error occurred
- Error index:
displays the position of the error in a circular list of 20 positions. Each error is ordered
based on the time it occurred (the most recent on top, the oldest below)
- Error text:
text description of the type of error
Reset errors This function resets the error list
Exit Through this option the user can go back to the menu top level