LawnMaster NPTGSP2517A - Page 31

31
AIR & FUEL SYSTEM
■ Remove and replace with a new fuel tank.
NOTE:
Make sure all parts are replaced in the exact order in which they were removed.
Insert the Fuel Tube
Connect the fuel tubes with the carburetor. The black tube is for fuel entering. The transparent is for
fuel return. The fuel tubes should be connected to the turning position as shown (Fig. 49).
NOTE:
Do not damage or fold the fuel tubes.
Fig. 48
Fig. 49
Exhaust System Service
(See Figs. 50-52)
■ Remove the rear engine cover refer to step 5 in Ignition System section.
■ Remove the 2 screws on the mufer by using the quincunx wrench to remove the mufer (Fig. 50).
Fig. 50
1
2
3
4
Fuel Return
Tube
(Transparent)
Turning Position
Fuel Tube (Black)
1
2