37
THROTTLE AND STARTER SYSTEM
■ Restore the microswitch into place (Fig. 69).
■ Connect the LED light cable to the electric starter cover plate. Always pull gently after assembly to
ensure that terminals of the LED cable are connected in place (Fig. 70).
Fig. 69
Fig. 70
■ Arrange the wirings inside the handle cover to make them straight. Then align the two ends of the
handle cover with the slots of the two rubbers on the shaft, and align the hole on the handle cover
with the hole on the shaft as shown in Fig. 71. Connect the handle cover and the shaft together, and
make sure they are installed in place. (Fig. 71 & 72).
Fig. 71 Fig. 72
To Next Page
Loading...
