29
Installation on Toyota MR2 or other VAST ignition
(AE86)
Toyota MR2 (or other VAST ignition)
Locate the ECU and verify this pinout:
IGT = Igniter = White
E1 = Ground = Brown
+B = Power from EFI main relay = Black/Yellow
+B1 = Power from EFI main relay = Black/Yellow
Cut the IGT wire and connect the end to the ECU to CH1 IN and the other end (to ignitor) to CH1 OUT
Connect Launch control 12V wire to ignition on power supply.
Connect GND wire to ground.
To Next Page
Loading...