LDG AT-200PC - Specifications

4
Specifications
• 5 to 250 watts SSB and CW. (100 watts on 6M)
• Two position antenna switch with memories for four antennas on each position
• Tuning time: 0.5 to 6 seconds full tune, < 0.1 second memory tune
• Built in frequency counter for memory operation
• Frequency coverage: 1.8 to 54.0 MHz.
• Tunes 6 to 1000 ohm loads (16 to 150 ohms on 6M), 6 to 4000 ohms with optional 4:1
Balun (LDG RBA 4-1)
• For Dipoles, Verticals, Vs, Beams or and Coax Fed Antenna
• Optional external Balun allows tuning of random length, long wire or ladder line fed
antennas
• Field upgradeable via software download
• Power requirements: 11 to 16 volts DC at 750 mA max during tuning
• Enclosure: 8.5 x 6.0 x 2.0 inches
• Weight: 2 pounds
IMPORTANT SAFETY WARNING
Never install antennas or transmission lines over or near
power lines. You can be seriousl
y
in
j
ured or killed if an
y
part
of the antenna, support or transmission line touches a power
line. Alwa
y
s follow this antenna safet
y
rule: the distance to
the nearest power line should be at least twice the len
g
th o
f
the lon
g
est antenna
,
transmission line or su
pp
ort dimension.