Leakomatic Pro1 - Volume Test Configuration; Volume Test M1 Settings; Volume Test M2 Settings

15
Volume test M1 (VTt, VTm)
Volume Test settings for a pulse water meter connected to the AUX1 input.
VTt
VTt Status
Specifies whether the hourly volume test will be
activated or not. If ”Turned off” is selected, the
VTt alarm times below do not have any effect.
Enabled/
Disabled
VTt Time Period
The length of the analysis period for the hourly
volume calculation.
0–24 hours
(24)
VTt Volume
Specifies the size of the volume that is permitted
to be used during the set VTt Time Period.
1–9999999
liters
VTt Alarm Delay
When a Volume Test Warning occurs, an extra
time is set here, during which the warning is
allowed to continue before the valve is closed.
0–24 hours
(1)
VTt Valve Management
Specifies if the valve will close on alarm.
None/
Close
VTm
VTtm Status
Specifies whether the minute volume test will be
activated or not. If ”Turned off” is selected, the
VTm alarm times below do not have any effect.
Enabled/
Disabled
VTm Time Period
The length of the analysis period for the minute
volume calculation.
1–60 min
(5)
VTm Volume
Specifies the size of the volume that is permitted
to be used during the set VTm Time Period.
1–999999
liters
VTm Alarm Delay
When a Volume Test Warning occurs, an extra
time is set here, during which the warning is
allowed to continue before the valve is closed.
0–120 min
(5)
VTm Valve
Management
Specifies if the valve will close on alarm.
None/
Close
Volume test M2 (VTt, VTm)
Volume Test settings for a pulse water meter connected to the AUX2 input. See description
above for ”Volume Test M1”.