16
INSTALLATION MENU
The installation menu contains settings that are usually set up at the same time as the
system. The menu has the following structure.
Security
PIN enabled Specifies whether the PIN code protection will be
activated for accessing the Installation menu.
Disabled/
Enabled
Change PIN
From the factory, the PIN code is 1234. The PIN code
can be changed to any four-digit code.
Enter PIN
Network
WiFi Determines whether WiFi has been activated.
Enabled/
Disabled
WiFi network Finds and lists available WiFi networks. Select the
network and give the password using arrows.
Confirm the password by pressing the right arrow
three times.
Cloud PIN Request a PIN code to connect to your Cloud
account. The code will be valid for 15 minute or
until a new code is requested.
Valve handling
Conditioning Determines whether Maintenance has been
activated. If ”Disabled” is selected, maintenance
will not be performed automatically.
Enabled/
Disabled
Time of day Indicated the time of the day when maintenance will
be performed.
00:00–23:59
(04:00)
Valve control
Specifies whether the valve can always close on
alarm or whether it can only close when it is in the
operating mode ”Away”. If ”Disabled” is selected, the
valve never closes and the alarm settings below do
not have any effect.
Away/
Enabled/
Disabled
On FT alarm
Specifies if the valve will close on FT alarm or not.
None/
Close
On QT alarm
Specifies if the valve will close on Quick Test alarm
or not.
None/
Close
On TT alarm
Specifies if the valve will close on Tightness Test
alarm or not.
None/
Close
Sensor diag. Automatic sensor test. If there hasn’t been any pulse
registered in the last seven days, a warning is given.
Enabled/
Disabled
To Next Page
Loading...
