28
ENGLISH
Terminal board J1
Terminal1 - Ground cable connection
Terminal2 - 230 Vac mains power supply phase
Terminal3 - 230 Vac mains power supply neutral
Warning : The power supply voltage polarities must be carefully observed.
Terminal board J4
Terminal1 – Output not available for the installer
Terminal2 – Electric lock 12
Vac power supply
Terminal3 – Electric lock 12
Vac and 24 Vac power supply (common)
Terminal4 – 24
Vac power supply for photo-cells or other devices
Terminal5 – Opening limit switch’s normally closed electric contact
Terminal6 – Closing limit switch’s normally closed electric contact
Terminal7 – Photoelectric cell’s normally closed electric contact (photostop)
Terminal8 – Common terminal for all electric contacts of limit switches and photostop
Terminal9 – Photo-cell’s normally closed electric contact
Terminal10 – Emergency push-button’s normally closed electric contact (stop)
Terminal11 – Opening Start or Start push-button’s normally open electric contact (dip switch 4 : off = opening Start, ON = Start)
Terminal12 – Common terminal for all electric contacts of commands and photo-cell
Terminal13 – Closing Start or Pedestrian Start push-button’s normally open electric contact (dip switch 4
: off = closing Start, ON = Pedestrian Start)
Important : The normally closed inputs not in use must be fitted with jumpers.
Terminal board J2
Terminal1 – Aerial cable connection (signal) for radio receiver card
Terminal2 – Aerial cable connection (shield) for radio receiver card
Connector J7
Terminal1 - Normally open electric contact connected to the opening start
Terminal2 - Common of the normally open electric contact connected to the opening start
Terminal3 - Normally open electric contact connected to the closing start
Terminal4 - Common of the normally open electric contact connected to the closing start
Terminal5 - 12 Vdc power supply negative (common)
Terminal6 - 12 Vdc power supply positive
Terminal7 - 12 Vdc power supply positive
Terminal8 - 12 Vdc power supply negative (common)
Terminal9 - Aerial input (shield)
Terminal10 - Aerial input (signal)
To Next Page
Loading...
