32
ENGLISH
FAR STORING
The control unit has a function called "Far Storing". It’s a special function that allows the insertion of new remote controls without the need to
operate manually on the receiver. The function "Far Storing" works only with SMARTY remotes (in rolling-code mode), ROLLY and all the
Leb’s rolling-code remotes, even out of production. The procedure is very simple, the only precaution to be observed is to perform operations
into the operating range of the receiver. To operate in "Far Storing", proceed as follows:
1 - On the new remote to be memorised, press the desired button for about 6 seconds until the Led switches off (on the remote);
2 - On a remote already memorised, press for 2 seconds the button relating to the device that must be controlled by the new remote control
(the blinker switches on with fixed light);
3 - On the new remote to be memorised, press the key already pressed to the point 1 for at least 1 second, the blinker switches off and the
new remote has been memorised.
To Next Page
Loading...
