LC Easyjet-16W/18S User Manual V13GZ.1
15
2.2.5.2 Load the Print Head
a. Dismantle the fixer for driving carriage.
b. Connect the power cable to LECAI printer, turn on the printer and then the driving carriage
starts to self-checking and moves back to the service station automatically.
c. Turn off the printer, push-off the carriage to be under the left front cover of the printer and
then remove the left front cover.
d. Remove the carriage cover, disassemble the damper holder and dismantle the ink dampers,
and remove the print head cover. Dismantle the three screws in the head bracket. Unpack
the protected adhesive tapes of the data wires.
e. Take out the print head, and connect the data wires to the connectors in print head.
Notice: Please pay attention to the order of the data wires when connect to the print head
and operate gently. Disorder or overexerting may cause permanent damage to data wires
To Next Page
Loading...