p.23 MyWay+ User Manual
• Position the user
on a plinth in a side
lying position.
• Place the harness under
the user using a rolling
technique, with the lower
edge of the harness just
over the top of the pelvis
(by about 2-3cm).
The user should be lying
in the centre of the open
harness once you have
nished positioning
the harness.
• Overlap the harness to
secure it around the user’s
waist by a minimum of
8-10cm, ensuring the
overlapping edges are
straight. The coloured tab
serves as an indicator to
show if the outer wrap
is in the correct position.
• Connect the groin straps
securely using the
black buckles.
• Adjust tautness as required
by pulling the black straps
on the groin strap.
• Release the stripe belt
strap , pull across the
user’s front and secure
to increase the support
around their trunk and
create a ‘hug’ effect.
• Connect the straps
situated above and below
the striped belt using the
black buckles
Adjust the
strap length if required.
• Check that the harness
is containing the top of
the user’s pelvis whilst
permitting hip movement.
10.2 Donning the Harness | In Lying
To Next Page
Loading...
