Leckey MyWay+ - Page 33

p.33 MyWay+ User Manual
Warning – be aware of nger placement when attaching/ detaching the adult handles to avoid
potential for nger nipping. The adult handles should not be used to lift the device.
Be aware of others within the environment where the device is being used and avoid the adult
handles making contact with them.
• To attach the headrest,
ip up the rubber cap
situated on the top of
the upper support unit
to expose the headrest
receiver slot.
• Insert the headrest
attachment pole into the
receiver slot, then turn
the handle in a clockwise
direction. Check the
headrest is secure.
11.2 Headrest
Note – when adjusting headrest height, take care
not to move/turn the handle on the headrest
attachment pole as this will make attaching the
headrest to the frame difcult.
Warning – Be aware of nger placement when
attaching/detaching the headrest to avoid
potential for nger nipping.
• To detach the headrest,
turn the handle in an
anti-clockwise direction
to unsecure the headrest.
Remove the headrest
attachment pole from the
receiver slot. Close the rubber
cap situated on the top of
the upper support unit.
• To adjust headrest height
the headrest must not be
attached to the product.
Unscrew both knobs and
remove them from the back
of the headrest. Move the
headrest attachment pole to
the desired position- there
are 3 positions to choose
from- and reattach the knobs
in this position. Attach the
headrest as per instructions
above.