p16 Squiggles Stander - User Manual
9.11 ASSEMBLE
THE TRAY
To attached the arms to the tray
brackets, loosen the knob , place the
moulding to the inside of the tray plate
so the plastic teeth mesh. Replace the
knob on the outside and secure. Repeat
on other side. Ensure both horizontal
tubes are aligned so they locate in the
tray bracket receivers.
9.12 ATTACHING THE
TRAY COVER
The tray cover attaches to the tray by
placing it over the top it will then clip into
place, to remove reverse the process.
To Next Page
Loading...
