EasyManuals Logo

LeCroy Waverunner2 Series User Manual

LeCroy Waverunner2 Series
155 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #75 background imageLoading...
Page #75 background image
Rev. D Performance Verification 5-39
DC Coupling
!
Recall
xxxP043.PNL
or configure the DSO :
Panel Setups :
Recall FROM DEFAULT SETUP
Channel Trace ON
Channel 2
Input Coupling :
DC 1M
Input gain :
1V/div
Input offset :
0 mV
Trigger setup :
Edge
Trigger on :
Ext/10
Slope Ext/10 :
Pos
Mode :
Auto
Coupling :
DC
Set Trigger level :
0.0 mV
External :
DC 1M
Pre-Trigger Delay :
50 %
Time base :
0.1 msec/div.
Record up to :
50 k samples
Channel Trace OFF
Channel 2
ANALYSIS CONTROL
Trace ON :
B
Select MATH TOOLS
For Math :
Use at most 5000 points
Redefine B :
Channel 2
Use Math ? :
Yes
Math Type :
Average
Avg. Type :
Summed
For :
10 sweeps
!
Connect the test equipment as shown in Figure 5-7.
!
Set the output of the LeCroy LW420 or equivalent audio frequency signal
generator to
1 kHz.
!
Adjust the sine wave output amplitude
to get
8 divisions peak to peak .
!
Select WAVE PILOT :
Cursors, Time, Absolute
!
Use the "cursor position" knob, to move the
Time marker
at 0.0
µ
s
!
Press
Clear Sweeps
!
Acquire 10 sweeps and record in Table 11 the
level
readout displayed below

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the LeCroy Waverunner2 Series and is the answer not in the manual?

LeCroy Waverunner2 Series Specifications

General IconGeneral
BrandLeCroy
ModelWaverunner2 Series
CategoryTest Equipment
LanguageEnglish

Related product manuals