Need help?Do you have a question about the LeCroy Waverunner2 LT354 Series and is the answer not in the manual?
General| Bandwidth | 350 MHz |
|---|---|
| Channels | 4 |
| Input Coupling | AC, DC, GND |
| Display | 10.4" Color LCD |
| Vertical Resolution | 8 bits |
| Input Impedance | 1 MΩ |
| Max Input Voltage | 400 V (DC + peak AC) |
| Trigger Types | Edge, Pulse Width, Pattern |
| Interface | GPIB |
Outlines LeCroy's product warranty terms and conditions for oscilloscopes and parts.
Details bandwidth, input impedance, resolution, and sensitivity for the vertical system.
Specifies time/div range, clock accuracy, and interpolator resolution.
Specifies trigger modes, sources, coupling, and delay parameters.
Procedure for checking the accuracy of the time base clock.
Explains the power supply unit's input voltages, overview, power switch, and cooling.
Details procedures for measuring input impedance at different couplings (DC/AC, 1MΩ/50Ω).
Describes the test for measuring leakage current across input channels.
Explains how RMS noise is tested on all channels with open inputs.
Test procedure for measuring DC accuracy of voltage measurements at 0V offset.
Test procedure for measuring offset accuracy at 5mV/div with a ±1 Volt signal.
Procedure to ensure the system meets bandwidth specifications using an external source.
Tests trigger capabilities for standard edge trigger cases.
Tests the smart trigger functionality for pulse width parameters.
Guide to troubleshooting common instrument issues using flow charts.
To Next Page