No Sound From Wavelet II
a. If any digital source components (USB, SPDIF, TosLink, AES/EBU) are connected, please make sure Wavelet is
turned on, before starting playback program or sending digital audio to it. USB devices speak with one another, and it
is possible for their initial “handshake” to be interrupted if the source and destination are not turned on in the proper
order. Digital source components should be powered on after Wavelet, then the input can be selected, and playback can
begin.
Sending digital audio to Wavelet, as with many digital audio devices, can cause the sound to stop playing. If this
occurs, power off your Wavelet and digital source device, then power Wavelet on, after 5 seconds you can power on
digital source components, input can be selected, and playback can begin.
b. If there aren’t any digital source components, confirm volume is at sufficient level (85-90 on front panel), mute is off,
and selected input source matches the audio connection at the Wavelet rear panel. Confirm cables are at correct ouputs
and amplifiers or active speakers are turned on.
Left Channel Pings appear on Right Channel or vice versa
a) Incorrect speaker connection- review your hardware connection diagram to insure your current connections are correct.
Message: “Error. Volume too Low” during Room Correction
a) Signal volume is too low- increase volume and repeat.
b) Verify that the microphone cable is securely connected to both the microphone and back of Wavelet II.
My unit will not fully power on/clicks for a few seconds then shuts off
a) Wavelet II was not allowed to fully boot due to receiving a premature digital signal. Please turn off all sources and
streams, unplug them from the back of Wavelet II, power Wavelet II off, wait 20 seconds and power back on.
b) Please always power Wavelet II on before digital sources.
c) If problem persists, please press and hold down Standby button to hard reboot Wavelet II.
No audio output from speakers
a) Please make sure the intended input source is selected.
b) Please disable the mute function. Mute light is illuminated when mute is enabled and will not be lit when mute is
disabled.
c) Please raise the volume to 90
To Next Page
Loading...
Need help?
General