d) Refer to the connection guide and confirm all inputs and outputs to the amps are correct
Distorted Sound
a) Signal input level is too high, causing clipping. Trim the input signal by toggling down the attenuator switches on the
back panel. Trims can be set at -3dB, -6db, or -12dB these values are additive and can sum up to -21dB per channel.
Loud pop on start-up
a) Please turn off all streamers, preamps, sources and amplifiers before turning on Wavelet II.
Output level on a channel is too low or high
a) Increase or decrease the channel level in the manual channel level adjustments.
Stereo Sound in Monophonic
a) Unit is in Mono mode, please choose Stereo Mode.
LED Display is too Dim or Bright
a) Click Settings, and choose Front Panel to adjust the brightness.
Wavelet II displays IP address but can’t connect
a) Wireless isolation is turned on within your router, please disengage in your router settings- this setting blocks
communication from devices within the network. If Wavelet II displays an IP Address, it has connected to your router.
To Next Page
Loading...