4.7 Settings shortcuts
There are two settings shortcuts:
- Bypass Mode: while the UPS is in normal mode (on-line, double conversion) press
and
simultaneously for approximately three seconds, until the buzzer sounds twice. The UPS
transfers from normal mode to bypass mode. During this functioning mode, the bypass LED
blinks and the buzzer sounds intermittently. Press again and simultaneously
until the buzzer sounds twice to return to normal mode.
- Eco Mode: while the UPS is in normal mode (on-line, double conversion) press
and
simultaneously for approximately three seconds, until the buzzer sounds twice. The UPS trans-
fers from normal mode to eco mode. During this functioning mode, the bypass LED
is on.
Press again
and simultaneously until the buzzer sounds twice to return to normal
mode.
4.8 Emergency Power Off (EPO)
The UPS has an external normally closed contact that can be opened to activate the immediate
stop of the UPS.
The EPO terminal is at the back of the UPS and it is needed for the functioning of the UPS.
To Next Page
Loading...
