5
ACTIVATING A HUB - QZHUB
1. To activate a QzHub ensure it is
plugged into a router. Enter the
6 digit code (located under the
battery cover), press and hold
the red button on the back to put
the hub in join mode, about 5
seconds. When the LEDs flash
tap the activate button.
2. Once the hub is activated you will
see it listed on the devices page.
Tap on it to begin joining shades.
ADDING A RANGE EXTENDER OR REMOTE
To add a range extender or remote to the network, follow these simple steps.
NOTE: You will not see a notification whether it joined on the app. Observe the device and its response to joining a Zigbee network.
1. Tap on your hub, put it into pairing mode
to allow your remote or extender to
join. Follow the device manufacturer’s
instructions to join it to the hub. See
page 13 for Qmotion remotes.
To Next Page
Loading...
