Leica IP C - Page 13

13
Leica IP C
Safety 2
Warnings – Instrument operation
Warning
• The instrument may be operated by trained laboratory personnel only. It must only be operated
for the purpose of its designated use and according to the instructions contained in these
Instructions for Use.
• The instrument is de-energized after disconnection of the power supply through the power cord
(power supply circuit breaker) - in emergencies, disconnect the power plug.
• Do not touch the chute during operation. Risk of injury.
• Do not open the reflector flap of the flash bulb while the instrument is ON – risk of burns and
blinding.
• The device operator is obligated to conform to the local workplace limit values and to document
them.
Warnings – Cleaning and maintenance
Warning
• Before any maintenance, switch off the instrument and unplug it from power supply.
• To clean the exterior surfaces, use a mild and ph-neutral commercial household cleaner. You may
not use: Alcohol, cleaning materials containing alcohol (glass cleaner!), abrasives or solvents
containing acetone or xylene! The painted surfaces and the control panel of the instrument are
not resistant to xylene or acetone!
• While working and during cleaning, no liquid may get into the interior of the instrument.