41
Leica IP C
Instrument Setup 4
Fig. 33
Connecting a remote alarm device
L If required, connect the external alarm system (optional) to jack (→ "Fig. 33-2").
1. The remote alarm device is connected to the printer via a 3.5 mm-diameter jack connector.
2. For details about the remote alarm see (→ p. 56 – 5.3 Alarm functions).
Warning
Any device that is connected to any one of the instrument interfaces must satisfy the requirements
for SELV circuits.
4.9 Exchanging the transport cartridge for an ink cartridge
In the factory condition, the printer is supplied with a transport cartridge (→ "Fig. 34-3") inserted. To be
able to print, the transport cartridge must be exchanged for an ink cartridge (→ p. 29 – 4.3 Standard
delivery). To do so, proceed as follows:
1. Open the cover plate (→ "Fig. 34-2") on the left side of the instrument (pressing its top left
corner).
2. Loosen the red cap (→ "Fig. 34-4") of the transport cartridge (→ "Fig. 34-3") by one turn, then
switch on the printer using the main switch on the rear side (→ "Fig. 32-3") and wait for it to
initialize.
To Next Page
Loading...
