72
Version 2.0, Revision I
Cleaning and Maintenance
6
Warning
• Switch off the printer and disconnect the power to prevent damage to the print head!
• Never use a transport cartridge together with a replacement plate!
• In order to use the printer again, the transport plate has to be removed and a new exchange plate
has to be inserted.
• Do not reinstall a used transport plate, as it will no longer completely seal the print head.
22. Likewise, clean the removed replacement plate (→ "Fig. 63-1") with the sealing lip
(→ "Fig. 63-2") with (clean) alcohol and a cleaning swab (→ "Fig. 63-3").
23. The sealing lip (→ "Fig. 63-2") must be completely free of ink residue. Check the sealing lip for
damage.
Warning
Do not reuse a replacement plate with a damaged sealing lip!
1
3
2
Fig. 63
24. Clean the instrument completely, as described in this chapter.
6.6 Transporting the instrument
If the printer is to be shipped, the storage instructions described above are to be carried out completely.
Then, additionally make the following preparations:
1. Open the hood (→ "Fig. 34-1") of the printer and loosen the screw of the flash cover.
2. Then take out the flash bulb. For more information, refer to (→ p. 32 – 4.6 Installing/
exchanging the flash bulb).
3. Close the flash cover and the hood.
4. Use original packaging and securely screw the printer to the baseplate (see unpacking
instructions).
5. Reinsert the transport anchor (→ "Fig. 14-1") and secure the hood with adhesive tape.
6. Make sure that the instrument is only transported upright.
To Next Page
Loading...
