7
3. Safety Notes
3. Safety Notes
3.1 Regulatory safety notes
Leica Microsystems utilizes regulatory model
names for all certified and CE marked products.
The regulatory model names are traceable to
all regulatory documentation, third party reports
and certifications.
“Regulatory Model: LED1/LED3/LED5/LED8 is
used as a representative model for all certified
and CE marked LED1/LED3/LED5/LED8 Products.
Emissions
This equipment has been tested and found to
comply with the limits of EMC directive 2014/30/
EU. These limits are designed to provide rea-
sonable protection against harmful interference
when the equipment is operated in a commercial
environment. This equipment generates, uses,
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instruction manual, may cause harmful interfer-
ence to radio communications.
It also meets the requirements of EN 61326-1,
Electrical equipment for measurement, control
and laboratory use – EMC requirements.
Photobiological Safety
The compact light sources have also been tested
in accordance with EN 62471 / IEC 62471 Photo-
biological safety of lamps and lamp systems and
is classified in risk group 3 (high risk).
Safety Certifications
TÜV SÜD America, CB Certification
(IEC 61010-1:2010)
TÜV SÜD America, NRTLus Certification
(UL 61010-1:2012)
TÜV SÜD America, cNRTL Certification
(CAN/CSA-C22.2 No. 61010-1:2012)
TÜV SÜD America, EN Certification
(EN 61010-1:2010)
CE Marking
Low Voltage Directive (2014/35/EU)
EMC Directive (2014/30/EU)
RoHS Directive (2011/65/EU) plus (2015/863/EU)
REACH Regulation (EC) No. (1907/2006/EC)
In accordance with the REGULATION (EU) No.
1194/2012 OF THE COMMISSION for the imple-
mentation of the Directive 2009/125/EC of the
European Parliament and Council with regard to
the requirements for the environmentally friendly
design of lamps with highly focused light, LED
lamps and associated instruments, the products
described here, Leica LED1, LED3, LED5 and
LED8, are special products because they are not
suitable for general lighting purposes.
To Next Page
Loading...
