MS60/TS60, Operation
46
Install Leica USB
drivers
Step Description
1. Start the PC.
2. Run the Setup_Leica_USB_XXbit.exe to install the drivers necessary for
Leica devices. Depending on the version (32bit or 64bit) of the operating
system on your PC, you have to select between the three setup files
following:
• Setup_Leica_USB_32bit.exe
• Setup_Leica_USB_64bit.exe
• Setup_Leica_USB_64bit_itanium.exe
To check the version of your operating system, go to Control Panel
> System > System type.
The setup requires administrative privileges.
The setup has to be run only once for all Leicadevices.
For PCs with Windows Vista/Windows 7/Windows 8/Windows 10
operating system: If not already installed, WMDC will be installed
additionally otherwise this panel would not appear. Click Install to
continue or Cancel to exit installation.
3. The Welcome to InstallShield Wizard for Leica GS, TS/TM/MS, CS and
GR USB drivers window appears.
Ensure that all Leica devices are disconnected from your PC before
you continue!
To Next Page
