MS60/TS60, Operation
48
Connect to PC via
USB cable step-by-
step
4.9 Power Functions
Turning the
Instrument On
Press and hold power key ( ) for 2 s.
The instrument must have a power supply.
Turning the
Instrument Off
Press and hold power key ( ) for 2 s.
The instrument must be on.
For instruments setup in permanent installations with external power sources,
for example monitoring, ensure external power remains available until the
instrument has successfully completed the power down process.
Power Options
Menu
Press and hold power key ( ) for 2 s to open Power Options menu.
Instrument must be on.
Step Description
1. Start the PC.
2. Plug the cable into the instrument.
3. Turn on the instrument.
4. Plug the cable into the USB port of the PC.
Windows Device Manager cannot be used with
CS20/TS16/TS60/MS60.
5. Press the Windows Start button at the bottom left corner of the screen.
6. Type the IP address of the device into the search field.
• \\192.168.254.1\ for field controller
• \\192.168.254.3\ for other instruments
7. Press Enter.
A file browser opens. You can now browse within the folders on the instru-
ment.
Option Description
Turn off Turn TS instrument off.
Stand-by Put TS instrument into stand-by mode.
In stand-by mode, the TS instrument shuts down and reduces
power consumption. Rebooting from stand-by mode is quicker
than a cold start after turning off.
Reset... Performs one of the following options:
• Restart (restarts Windows EC7)
• Reset Windows EC7 (resets Windows EC7 and communication
settings to factory defaults)
• Reset installed software (resets settings of all installed software)
• Reset Windows EC7 and installed software (resets
Windows EC7 and settings of all installed software)
To Next Page
