MS60/TS60, Operation
53
When a measurement is triggered while the prism is still moving, distance and angle
measurements may not be made for the same position and coordinates may vary.
If the prism location is changed too quickly, the target may be lost. Make sure that the
speed does not exceed the figure given in the technical data.
Motorised Posi-
tioning
Unstable instrument setup conditions or small vibrations of the instrument resulting
from heavy traffic or construction activities in the vicinity of the instrument may lead
to an abandonment of the instrument’s positioning before the final position is
reached. Ensure that the instrument setup is stable, especially if steep sightings are
necessary. If an incomplete positioning is indicated check the position deviation and
repeat the according positioning command.
To Next Page
