5252
RTJ400 User Guide
Box Joint Procedures - 3/8"
Chapter 10
10-44 Flushness IMPORTANT NOTE: Do not adjust flushness
until correct joint tightness in previous steps is achieved.
For over flush tails
,
move the frame pin to a minus (“–”) tail position
and rout a new test joint.
You must re-center the tail
board and reposition the sidestop every time a reset for
flushness is made
. Each pin position changes the joint flushness by
0.013"[0.33mm] Record the pin setting for future use.
Note:
Tail board thickness will not affect flushness.
OVER FLUSH
10-45 Flushness IMPORTANT NOTE: Do not adjust flushness
until correct joint tightness in previous steps is achieved. For
under flush tails, move the frame pin to a plus (“+”) pin position
and rout a new test joint.
You must re-center the tail
board and reposition the sidestop every time a reset for
flushness is made
. Each pin position changes the joint flushness
by 0.013"[0.33mm] Record the pin setting for future use.
Note:
Tail board thickness will not affect flushness.
■
UNDER FLUSH
3/8" Half-Blind Box Joints cont.
10-43 Finish routing in and out of all template openings.
The eBush must touch one side of the opening as you enter
and the other side as you exit.
To Next Page
Loading...
