2
DANGER! Danger when opening up the tool, as live com-
ponents and connections are exposed. Therefore, before
opening the tool, unplug it to ensure disconnection from
the mains.
Incorrect use of the hand extruder (e.g. overheating of the
material) can present a fire and explosion hazard, espe-
cially near combustible materials and explosive gases.
The tool must be operated with supervision. Heat can
reach combustible materials, which are out of sight.
For personal protection on building sites we strongly recom-
mend the tool be connected to a RCCB (Residual Current
Circuit Breaker) .
The voltage rating stated on the name plate of the tool
must correspond to the mains voltage and frequency.
Danger of getting burned! Do not touch exposed hot metal
parts and escaping plastizised material. Let the tool cool
down. Do not point the hot air flow and the escaping
plastizised material in the direction of people or animals.
Protect tool from dampness and wet.
FI
120
230
WARNING
CAUTION
TECHNICAL DATA
Voltage V~ 230
Power consumption W 3500
Frequency Hz 50/60
Air flow (20°C) l/min ca. 300
Air temperature °C max. 350
Plasticizer temperature °C max. 280
Welding output kg/h ø 3 PE 1.6 - 2.3 ø 3 PP 1.3 - 2.0
(Average values at 50 Hz) ø 4 PE 2.0 - 3.5 ø 4 PP 1.5 - 2.7
Welding rod mm ø 3 / ø 4 ± 0.2 (in accordance with DVS 2211)
Size L × W × Hmm670 × 90 × 180 (without welding shoe)
Weight kg 7.2 with 3m cable
Mark of conformity ¬
Mark of approval †
Certification scheme CCA
Protection class II ¶
Line/mains voltage cannot be switched over
To Next Page
Loading...
