7
BA FUSION 3 / 11/2004
• Only Leister accessories must be used.
• In case of soiling clean the air inlet on the hot air blower with a brush.
• Clean the
extruder nozzle (17) each time the welding shoe is replaced and
remove any welding deposits.
• Check power supply cord (1) and plug for electrical and mechanical damage.
• At minimal length of the carbon brushes the motor switches off automatically.
The tool should be checked by your Service Centre.
The carbon brushes will last approx. 1000 hours running time.
• Have the condition of the carbon brushes checked by your Service Centre after
approx. 200 hours of running time.
• Repairs should only be carried out by authorized Leister Service Centres. They
guarantee a specialised and reliable Repair Service within 24 hours using original
spare parts in accordance with the circuit diagram and spare parts list.
• Guarantee and liability are in accordance with the guarantee certificate as well
as with the currently valid general conditions of business and terms of delivery.
• Leister Process Technologies rejects any guarantee claims for tools which are not in
their original condition. The tools must never be altered or changed.
Technical data and specifications are subject to change without prior notice.
Your authorized Service Centre is:
GUARANTEE AND LIABILITY
SERVICE AND REPAIRS
MAINTENANCE
ACCESSORIES
®
Leister Process Technologies, Riedstrasse, CH-6060 Sarnen/Switzerland
Tel. + 41 41 662 74 74 Fax +41 41 662 74 16
www.leister.com sales@leister.com
To Next Page
Loading...
