LEM blues series - MASTER Section

5
BLUES
MASTER section
IN
AUX
MONO
MON
LEFT
PHONES
RIGHT
-20
-5
-20
-5
dB
dB
AUX
MON
+4
0
0
-10
0
+4
0
0
-10
0
1. AUX OUT
Balanced JACK connector (+4dB): this connector feeds out the sum of the
signals arriving from the relative AUX sends of the input channels. The AUX send
is POST-FADER and therefore mainly intended for use with OUTBOARD EFFECTS.
2. MON OUT
Balanced JACK connector (+4dB): this connector feeds out the sum of the
signals arriving from the relative MON send of the input channels. The MON send
is PRE-FADER and therefore mainly intended for use with MONITORS.
3. AUX
Pot for controlling the level of the AUX MASTER: controls the overall level of
all the signals arriving from AUX send of the input channels, which are then routed
to the AUX OUT output.
4. MON
Pot for controlling the MON MASTER level: controls the overall level of all the
signals arriving from the input channels MON send which are then routed to the
MON OUT output.
5. MIX L&R OUT
Two balanced JACK connectors (+4dB): these are the connectors of the mixers
main outputs and feeds out the main signal arriving from MIX L&R.
6. MONO OUT
Balanced JACK connector (+4dB): the connector of the mixers mono output
and feeds out the mono signal formed by the sum of the MIX L&R signals.
7. TAPE OUT L&R
Two RCA pin connectors (0dB): these feed out the signal taken from MIX and
normally intended for STEREO recording.
8. TAPE IN L&R
Two RCA pin connectors (0dB): receive external signals from STEREO tape
recorders, CD players, DAT decks, etc.
9. TAPE IN
TAPE IN input level control: regulates the level of a signal arriving from an
external tape recorder to MIX L&R.
MASTER section
TAPE IN
IN
MONO
RIGHT
TAPE
LEFT
OUT
LEFT
RIGHT
dB
0
0
0
-20
-10
-5
1
2
3
4
5
678
9