Need help?Do you have a question about the LEM blues series and is the answer not in the manual?
General| Brand | LEM |
|---|---|
| Model | blues series |
| Category | Music Mixer |
| Language | English |
Overview of the LEM BLUES series mixing consoles and their key features.
Instructions for safely connecting the mixer to the power supply.
Proper procedure for powering the mixer and connected amplifiers on and off.
Advice on avoiding interference and ground loops in audio setups.
Recommendations for handling, maintaining, and protecting audio connection cables.
Guidelines for protecting the mixer from environmental factors and basic maintenance.
Overview of the mono input channel controls and their arrangement.
Details on the balanced XLR microphone input connector.
Details on the balanced JACK line input connector.
Regulates input signal amplification for microphones and line sources.
Description of the HIGH and LOW equalization controls.
Controls for EFX, AUX, and MON send levels.
Stereo panning and channel muting functions.
LEDs for signal peaks/presence and the channel output level fader.
Introduction to stereo input channels for handling stereo equipment.
Details on RCA phono and balanced JACK line input connectors.
Switches for selecting input source and summing stereo signals to mono.
Balance control and fader for stereo channel output level.
Introduction to the master section controls for overall mixer management.
Controls for master AUX and MON send outputs and their levels.
Controls for main MIX L&R, MONO OUT, and TAPE IN/OUT.
Controls for headphone output connector and volume.
Displays and power indicators for the mixer.
Button to supply phantom power to MIC inputs.
Connectors for external power supply and DSP footswitch.
Information on the built-in digital stereo multi-effect processor and its effects.
Details on the reverb and multi-effect algorithms and their presets.
Explanation of the TAP DELAY effect and tempo setting procedure.
Layout and functions of the DSP control panel.
Details on DSP indicators (DISPLAY, PEAK, TAP ON, EDIT) and the joystick.
Description of the 4-position FILTER selector and its EQ curves.
Details on connecting the 5-pin power supply connector.
Instructions to ensure proper airflow for the power supply unit.
To Next Page
