LEM blues series - Dsp

7
BLUES
MASTER section
The BLUES DSP is a DIGITAL STEREO MULTI-EFFECT made up of two distinct
sections:
 REVERB Section é ROOM (PRESETS 1-4)
HALL (PRESETS 5-8)
VOCAL (PRESETS 9-12)
PLATE (PRESETS 13-16)
 MULTIEFFECT Section é CHORUS (PRESET 17)
FLANGER (PRESETS 18-19)
PHASER (PRESETS 20-21)
STEREO DELAY (PRESETS 22-24)
MONO DELAY (PRESETS 25-27)
DETUNE (PRESET 28)
PITCH (PRESET 29)
EDITABLE DELAY (30-31)
TAP DELAY (32)
MUTE (00)
Using the joystick, the PRESETS can be selected continuously and, once the end of
the series is finished starts again at the first PRESET is returned to.
The joystick is used to change the parameters of the four editable PRESETS. All
changes carried out are stored in the units memory, even when the mixer is
switched off.
 TAP DELAY
TAP DELAY is a delay effect in which the time is manually set by the user following
the tempo of the piece of music with which the effects has to be used. The procedure
for setting the delay time is very easy é
1) Once PRESET 32 has been selected and the reference piece of music is being
played back, moving the joystick to the left the procedure for acquiring the tempo
is enabled (the TAP ON LED flashes and the DSP signal stops).
2) Moving the joystick to the right in time with the music (at least twice), the
tempo is set (BEAT COUNTER).
3) Now moving the joystick to the left again, the set time is stored, the DSP is
enabled again and the PRESET can be used with the required delay time (the TAP
ON LED goes off.
Delay time set in this manner is stored until another variation is made.
DSP