LEM blues series - Power Connector; Connection Cables; Ps 30 Power Supply Unit

10
BLUES
Connector cables
TIP
GROUND
SIGNAL
SLEEVE
TIP
RING
GROUND
HOT
(
+
)
SLEEVE
COLD
()
Balanced XLR-M connector
3
GROUND
HOT
(
+
)
COLD
()
1
2
CONNECTION CABLES
Balanced JACK connector
RCA pin connector
PS 30 POWER SUPPLY UNIT
1. MAINS POWER CORD
Cord for connection to the mains power supply
2. POWER CONNECTOR
5-pin power supply connector: connect this to the power supply
socket (AC) on the rear of the BLUES mixer.
3. POWER
ON button: before switching on the power supply unit, make
certain that the mains voltage is the same as that shown on the
unit (a tolerance of ±10% is allowed for).
4. COOLING VENTS
Make certain to avoid blocking these vents and positioning the power supply unit
in places in which there is insufficient air circulation for cooling.
2
3
4
1