including Wi-Fi Protected Setup (WPS).
To connect MSY3 to your network, you need a Wi-Fi wireless router, together with
password key if set Select WLAN region/country >Wi-Fi network (SSID), and then select
a network from the list.
If the network is open (non-encrypted), MSY3 connects and no further details are
required; see Completion below.
Standard encrypted network
To enter the network’s key (password), use the Select control to highlight the next
relevant character and press to select each character in turn. As each character is
selected, the key is built up near the top of the display.
The three options – Backspace, OK and Cancel are included in the selection loop.
These can be accessed just usin
g the Select control, or, a short cut is available,
pre
ssing the Info key, which moves the selection highlight to the BackSpace option.
WPS setup
WPS encrypted networks are identified by ‘[WPS]’ at the start of the network
name, and have two methods of connection. Select one and follow the prompts. When
using the network wizard an additional option to Skip WPS is available.
Select one and follow the prompts:
13
To Next Page
Loading...
Need help?
General
