shows the Save preset screen. Select one of the 20 presets to save the currently
playing station.
To select a preset, press P
res set briefly, then select one of the listed Preset stations.
When a preset station is playing, it shows
1,2,3 etc in the bottom middle of the
screen.
7
.2 Now playing information
While an FM station is playing, the screen shows one of the two following sets data:
If RDS information is available, by default the service name (i.e. station name) is
displayed.
You can cycle through further RDS information by pressing I
nfo .Each time you press
I
nfo, another set of information is displayed, cycling through RDS radio text, RDS
programme type, frequency and today’s date.
If no RDS information is available, the currently tuned frequency is shown.
7
.3 Settings
Scan settings
By default, FM scans stop at any available station. This may result in a poor
signal-to-noise ratio (hiss) from weak stations. To change the scan settings to stop only
at stations with good signal strength, select M
enu > Scan setting > Strong stations only?
> Yes.
Audio settings
By default, all stereo stations are reproduced in stereo. For weak stations, this may
result in a poor signal-to-noise ratio (hiss). To play weak stations in mono, select
M
enu >Audio setting > FM weak reception: Listen in mono only > Yes.
8
AUX mode
Aux in mode plays audio from an external source such as an MP3 player.
To play audio with Aux in mode,
1).Connect the external audio source to the Aux In (RCA) stereo socket.
2). Either press M
ode until the display shows AUX in or select Menu> Main menu >
AUX in.
3). Adjust the volume of MSY3 (and, if necessary, the audio source device) as required.
23
To Next Page
Loading...
Need help?
General
