If reception was not good for the original scan (for example the antenna was not up),this
may result in an empty or incomplete list of available stations.
If you have poor reception of some stations (burbling), you may wish to list only stations
with good signal strength.
To start a scan manually, select M
enu > Scan.
Once the scan is complete, the radio shows a list of available stations.
To remove stations that are listed but unavailable, select M
enu > Prune invalid.
6
.2 Selecting stations
To listen to or change a station, turn the Select control to view a list of stations and
press to select. Once selected, the station plays and the screen shows information
ab
out the station, track or show as broadcast.
P
resets
s
s
To store a DAB preset, press and hold Preset until the display shows the Save preset
screen.
Sel
ect one of the 20 presets (on the remote) to save the currently playing station.
To select a preset, press P
reset briefly, then select one of the listed preset stations.
When a preset station is playing, it shows
1,2,3 etc in the bottom middle of the
screen.
6
.3 Now playing information
While the stream is playing, the screen shows its name and DLS (Dynamic Label
Segment) information broadcast by the station giving real-time information such as
programme name, track title and contact details. Stereo broadcasts are indicated with
an icon at the top of the screen. To view further information, press I
nfo .
Each time you press Info, another set of information is displayed, cycling through DLS
text, programme type, ensemble name/frequency, signal strength/error rate, bit
rate/codec/channels and today’s date.
6
.4 Settings
Dynamic range compression
Some DAB broadcasts offer dynamic range compression (DRC). This feature allows
radios to compress the dynamic range of the output audio stream, so that the volume of
21
To Next Page
Loading...
Need help?
General
