Cursor up button, move up in the menus and change to the next channel in
viewing mode.
Cursor down button, move down in the menus and change to the previous
channel in viewing mode.
PIC Press to open the picture mode menu.
Cursor left button, move left /change settings in menus. Decrease the volume
level in viewing mode.
Cursor right button, move right /change settings in menus. Increase the volume
level in viewing mode.
0~9 Press to change the channel and to select individual menu options.
LANG Press to change the menu languages.
TTX Press to enter Teletext (if available) (only Digital TV Mode)
INFO Press to display the information of the current programs. (At Digital TV Mode)
S.TIT Press to display the subtitle of the current programs. (only Digital TV Mode)
L/R Press to change the sound channel (At Digital TV)
Or audio mode ( At ATV, AV and VGA mode).
EPG Press this button to display Electronic Program Guide (only Digital TV Mode)
3.2 Preparing the remote control
Remove the cover from the battery compartment at the bottom of the remote control.
Insert the battery, taking care to observe the “+”and “–” markings indicated inside.
Replace the cover.
! Attention: This remote controller’s figure maybe different to the remote controller what you
obtained. But the symbols and functions on the remote controller are the same as this figure.
The remote control range is 4M or less within a±45°horizontal and ±5°vertical angle from
the remote sensor. If the remote’s battery is low, the remote may not function properly, so
replacing the battery immediately is recommended.
To Next Page
Loading...
