Page 10
507518-02
SETTINGS - Filter/Maintenance Reminders
The thermostat is designed to remind you when the filter
needs changing or when routine maintenance is required,
as (and if) defined, by you. These optional reminders are not
enabled until you activate them. To do so, press the
SETTINGS button (shown below the Fan button in figure
13) once or twice for the desired reminder as shown in figure
14 and as described in table 1.
FILTER
off
MAINT
For FILTER,
press Settings
button 1 time
For MAINT,
press Settings
button 2 times
Figure 14. Reminder Settings Display
The default setting for the reminders is OFF (disabled).
Press either the up or down arrow buttons to select the
desired reminder intervals.
Table 1. Filter and Maintenance Reminders
Buttons to
Use
Reminder
Available Settings and How
to Use
Settings
(1st press)
then Arrows
to scroll
selections
FILTER
Total fan run time expressed in
months (Off, 1, 3, 6, 12); for
example, if fan runs 12 hours a
day, 1 month reminder displays
in 2 calendar months.
Settings
(2nd press)
then Arrows
to scroll
selections
MAINT
Elapsed chronological time in
months (Off, 6, 12). Use this, for
example, to remind yourself
when to perform routine checks
or when to call a technician for
periodic preventive
maintenance.
Enter Stores settings.
NOTE - The HOME screen will reappear about 15 seconds
after the final arrow button press. OR, press ENTER at any
time to store any changes and exit to the HOME screen.
After either programmed interval has elapsed, the reminder
will be displayed as shown in figure 15.
To Next Page
Loading...
Need help?
General
