22
Compressor Protect
Default is ON and it can be turned OFF, however
only for one compressor cycle and then it will revert
back to ON.
If the system is running in compressor protection,
the home screen will display “WAITING” only if there
is a compressor cooling or heating call (Y1/Y2).
If compressor protection is running and there is a
demand for electric heating, the system waits for the
compressor protection timer to expire.
Humidity Settings
See page 24 for dehumidify mode.
Custom Reminders
Two custom reminders may be rename on this
screen to the desired name (name is limited to 19
characters). After entering the new name, touch the
done key to return to the customer reminder screen.
To set a reminder go to the User Settings screen and
select reminders. The reminder setting screen will
appear and a list all of the predefined reminders plus
the two custom reminders will appear at the end of
the list.
Scroll to CUSTOM REMINDER 1 or 2 (or renamed
titles). Touch the title to select the reminder. By
default all reminders are set to disabled. Touch
disable to choose from 3mon, 6mon, 12mon, 24mon
or custom date.
When finished, touch < to return to previous menu.
Reset Settings
To reset the thermostat to factory defaults, scroll to
RESET SETTINGS and touch to select. Read the
message and to continue touch CONFIRM.
IMPORTANT
RESET SETTINGS erases all programming and
returns the thermostat to the factory conditions,
including the installer settings. Use this only as a
last resort.
To Next Page
Loading...
