Page 7
11 - Inspect the furnace return air duct connection to
ensure the duct is sealed to the furnace. Check for
air leaks on supply and return ducts and seal where
necessary.
12 - Check the condition of the furnace cabinet insulation
and repair if necessary.
13 - Perform a complete combustion analysis during the
furnace inspection to ensure proper combustion
and operation. Consult Service Literature for proper
combustion values.
14 - Verify operation of CO detectors and replace
batteries as required.
Perform a general system test. Turn on the furnace to
check operating functions such as the start-up and shut-
RႇRSHUDWLRQ
1 - Check the operation of the ignition system, inspect
DQG FOHDQ ÀDPH VHQVRU &KHFN PLFURDPSV EHIRUH
and after. Check controls and safety devices (gas
YDOYH ÀDPH VHQVRU WHPSHUDWXUH OLPLWV &RQVXOW
Service Manual for proper operating range. Thermal
/LPLWVVKRXOGEHFKHFNHGE\UHVWULFWLQJDLUÀRZDQG
not disconnecting the indoor blower. For additional
details, please see Service and Application Note
+
2 - 9HULI\WKDWV\VWHPWRWDOVWDWLFSUHVVXUH DQGDLUÀRZ
VHWWLQJVDUHZLWKLQVSHFL¿FRSHUDWLQJSDUDPHWHUV
3 - Clock gas meter to ensure that the unit is operating
DW WKH VSHFL¿HG ¿ULQJ UDWH IRU HDFK VWDJH RI
operation. Check the supply pressure and the
PDQLIROGSUHVVXUHRQERWKORZ¿UHDQGKLJK¿UH,I
manifold pressure adjustment is necessary, consult
WKH 6HUYLFH /LWHUDWXUH IRU XQLW VSHFL¿F LQIRUPDWLRQ
on adjusting gas pressure. Not all gas valves are
adjustable. Verify correct temperature rise.
5HSDLU3DUWV/LVW
The following repair parts are available through Lennox
dealers. When ordering parts, include the complete fur-
nace model number listed on the CSA International name-
SODWH ([DPSOH (/8+;(% $OO VHUYLFH PXVW
EHGRQHE\DOLFHQVHGSURIHVVLRQDOLQVWDOOHURUHTXLY-
DOHQWDVHUYLFHDJHQF\RUWKHJDVVXSSOLHU
&DELQHW3DUWV
Upper access panel
Blower access panel
Top C a p
&RQWURO3DQHO3DUWs
Transformer
Integrated control
Door interlock switch
%ORZHU3DUWV
Blower wheel
Motor
Motor mounting frame
%ORZHUKRXVLQJFXWRႇSODWH
+HDWLQJ3DUWV
Flame Sensor
Heat exchanger assembly
Gas manifold
Combustion air inducer
Gas valve
Main burner cluster
0DLQEXUQHURUL¿FHV
Pressure switch
Ignitor
Primary limit control
Flame rollout switches