Lennox iComfort Wi-Fi® Thermostat - PC Welcome Screen, Interactive Demo and Gelaskins

507342-01
Page 26
NOTE - Firmware updates will not affect installer or user thermostat settings.
Both will be retained after the update.
WI-FI SETTINGS
connected
Wi-Fi
enabled
thermostat
registered
Connection to server has not bee established or it has been lost.
Please wait until a connection is established.
firmware
update
auto
press to enable /
disable Wi-Fi
press to change
wireless network
press to change
thermostat
registration
press to search
for new update
NOTE -
If any downloads are available for the thermostat they will start down
loading right away. After the new firmware has been downloaded and
the thermostat is ready to update itself, the thermostat screen will tem
porarily go blank and running units may cease operation while the sys
tem is being reset to accommodate the new changes. This is normal
and can last a couple minutes.
AP3
connection
status
press to see
connection status
Figure 44. Registration for Online Access
Personal Computer Welcome Page; Interactive Demo;
Online iComfort
®
information; Using Gelaskins
Figure 45. PC Welcome Screen
Access all the great Wi-Fi enabled features on your icomfort
®
thermostat
from our secure web portal. After signing in, you’ll be able to view your
icomfort system settings, adjust the temperature and view reminders and
alerts – just as you would on your icomfort thermostat at home. With a
familiar look and settings this simple, you should feel right at home. Don’t
forget to check out the available Apps and customizable skins using the links
on the right side of the page. From the welcome page, you may also click on
links to launch an interactive demo or learn more about icomfort.
HOW DO I TURN ON SKINS ON THE ICOMFORT WI-FI
THERMOSTAT?
From the thermostat Home screen, press then display setting then
screen saver buttons. From the pop-up menu, select skins. The skin
picture will appear after 30 seconds of inactivity.
HOW DO I UPLOAD A SKIN?
Skins should be ordered from website listed below:
http:// www.gelaskins.com/lennoxicomfort
After ordering the skin, Gelaskins will email the image file (.jpg) to the
homeowner. This “jpg” has been altered to display correctly on the icomfort
Wi-Fi Thermostat. Images can be uploaded to the icomfort Wi-Fi thermostat
from the consumer portal site (www.myicomfort.com) under the tab ”skins”.