Lennox icomfort Wi-Fi - Page 11

iComfort Wi‐Fi
®
7-Day Programmable Communicating Thermostat
11
6. After registration has been completed, press the connection status
icon to verify the connection was successful. If the connection is
successful the server icon background will be green.
7. After successful connection to the server is completed, the firmware
update button will appear. The default setting is set to auto. If any
firmware updates are available they will immediately start downloading
and update the thermostat. The thermostat will reboot itself after the
update is completed. Updates are done in the background and will not
impair normal thermostat operations.
This auto update feature can be disabled by pressing the firmware
update button to toggle to OFF but is not recommended.
NOTE - Firmware updates will not affect installer or user thermostat settings.
Both will be retained after the update.
WI-FI SETTINGS
connected
Wi-Fi
enabled
thermostat
registered
Connection to server has not bee established or it has been lost.
Please wait until a connection is established.
firmware
update
auto
press to enable /
disable Wi-Fi
press to change
wireless network
press to change
thermostat
registration
press to search
for new update
NOTE -
If any downloads are available for the thermostat they will start down
loading right away. When new firmware is being downloaded, the ther
mostat screen will temporarily go blank and running units may cease
operation while the system is being reset to accommodate the new
changes. This is normal and can last a couple minutes.
AP3
connection
status
press to see
connection status
Figure 12. Registration for Online Access