507341-01
14
Adjusting Humidification and Dehumidification Settings with
Communicating Outdoor Units
HUMIDIFICATION SETTINGS — FEATURE SCREEN
1. From the Main Screen, touch the right arrow icon to go the the
Features screen.
2. From the Features screen, select system settings.
3. Touch the button of the humidification controls you want to adjust; if it
says humidifier OFF, one touch will display a selection for ON.
4. When you touch the set-to button, the arrows appear, allowing you to
change to the desired humidity percentage setting.
SYSTEM SETTINGS
heating
mode
COMFORT
humidifier
is ON
Appears only
when heat pump
is present
Select the humidity
level that matches
your regional weather
9:39 am Aug 15, 2012 ?
Wi-Fi
35
%
set to
40
%
set to
humidification
settings
dehumidification
settings
ClimateIQ
setting
MOD
humidifier
display
is ON
Figure 14. System Settings Screen (Example Only) -
Communicating Outdoor Unit
DEHUMIDIFICATION SETTINGS — SYSTEM DEVICES SCREEN
Pre-adjustment REQUIREMENTS:
First, the device has been installed
Second, from the “Add or Remove Non-communicating equipment?”,
touch next.
Third, in the “Adjust a setting...” screen, configure the device as
follows:
1. In the “system devices” list, use the arrows to highlight System. Touch
edit.
2. Humiditrol
®
only—In the “System” list, use the arrows to highlight
Humiditrol Comfort Adjust. The current value defaults to Maximum
Overcooling. Touch edit.
3. Humiditrol
®
only—Touch one of the radio buttons to select the
overcooling level; touch save. (After saving, check that the current
value now shows the new selection).
4. Use arrows to highlight Min Dehumidification Setpoint; touch edit.
Note the current value (e.g. 45).
5. Use arrows to make changes; touch save. (After saving, check that the
current value now shows the new selection).
6. Touch the back button to return to “Adjust a setting...” screen.
DEHUMIDIFICATION SETTINGS — FEATURE SCREEN
1. From the Main Screen, touch the right arrow icon to go the the
Features screen.
2. From the Features screen, select system systems.
3. Touch the ClimateIQ setting button. Available options when selected
are selection for DRY, MODERATE and HUMID.
4. Selecting HUMID bring on the set-to button. When you touch the
set-to button, the arrows appear, allowing you to change to the desired
de-humidifier percentage setting.
SYSTEM SETTINGS
heating
mode
COMFORT
humidifier
is ON
ClimateIQ
setting
MOD
humidifier
display
is ON
Appears only
when heat pump
is present
humidification
settings
dehumidification
settings
(default is DRY)(default is ON)
(default is ON)
Select the humidity
level that matches
your environment
9:39 am Aug 15, 2012 ?
Wi-Fi
35
%
set to
40
%
set to
Figure 15. Humidifier Controls (Communicating Outdoor Unit)
To Next Page
Loading...
